正面
涂爵士·普罗斯旺（滚涂）
TUJUESHI
持续释放清新负氧离子、清除甲醛、调湿、净化空气，时刻呵护家人健康
全国免费服务热线：
涂爵士（中国）品牌运营机构 深圳市新涂爵士建材有限公司
地址：广东省深圳市南山区深南大道9039号博耐家居广场A2083、2085
地址：广东省深圳市龙华新区清丽路1号
Provence Roll Series
Tujues WALL Materials
Releasing Anion
·Releasing anion
·Adjusting the humidity
·Purifying air
·Preventing mildew and resisting bacterium
涂爵士硅藻泥·普罗斯旺（滚涂）
采用纯天然深海硅藻土、进口纳米材料及天然无机硅等原料，添加天然负离子素，利用光的作用使墙面持续消除甲醛、苯等有害气体，有效清除家居异味、抗菌、净化室内空气，时刻呵护家人健康。
应用范围：适用于中、高端别墅、住宅及星级以上酒店、商业、休闲、娱乐中心等。
施工方法：刷涂、滚涂
理论耗漆量（以干膜30μm计）：
30-50平方米/桶，实际施工面积会因施工方法、墙面粗糙度及施工环境而有所差异。
注意事项：
为达到最佳涂装效果，可以根据实际施工工艺要求进行施工，使用前应搅拌均匀，过滤最佳。
产品功能：
1、 负离子功能：持续释放对人体有益负离子，使室内负离子含量达到生态草原负离子含量标准。
2、 呼吸调湿功能：可以有效调节室内空气湿度，改善室内空气质量，特别是针对沿海地区和梅雨地区出现的墙面出水现象起到有效遏止。
3、 防霉抗菌功能：防止墙面出现霉变并对金黄葡萄球菌、大肠杆菌抑菌率高达99%。
4、 空气净化功能：对室内甲醛、异味等有害气体净化率达90%以上。
5、 光触媒功能：采用最新纳米科技光触媒技术，利用二氧化钛作为催化剂配合日光或灯光反应，分解空气中对人体有害物质而放出氧气，可长期保持空气净化功能。
底材处理：
涂装体系及涂装遍数：
干燥时间(以25℃计):
l 表干：2小时
l 硬干：8小时
l 重涂：至少间隔8小时(完全固化：夏天2天，冬天3天，潮湿天气适当延长)
施工条件：
请不要在潮湿或寒冷的天气(气温低于5℃，相对湿度大于85﹪)情况下施工。否则不能达到预期的涂装效果。
保养时间：
7天25℃，潮湿天气或者气温过低，适当延长时间以获得最佳效果。
清洗：
涂装中途停顿或涂装完毕，请及时使用清水清洗所有器具。
贮存：
存放于0-35℃阴凉干爽通风的地方,开罐后未使用完的产品应密封保存 。
安全事项：
l 请务必于使用前仔细阅读产品包装及标签中的施工说明，以获得可靠和满意的涂装效果。
l 在开始操作和使用前尽量打开所有的门窗，确保施工区域有足够的通风条件。
l 如属过敏性皮肤，请在使用中始终佩戴防护用具，如不慎沾染眼部，请立即用大量清水冲洗，并寻求医疗救助。
l 请不要让儿童或宠物进入施工区域，并将产品储存于他们接触不到的地方，如不慎沾染，立刻用大量清水冲洗，并寻求医疗救助。
l 为确保最佳涂装效果，请有效分隔、覆盖和遮蔽木质品与墙面的区域，更好地维护施工现场的清洁。避免混乱施工操作，请按照先施工木器漆，待干燥后再去施工壁材的施工顺序操作。
环保事项：
本产品不添加任何重金属等有害物质，符合最新内墙装饰材料有害物质限量的国家标准及中国环境产品技术要求。
执行标准：GB/T9756-2009 GB18582-2008
保质期：有效存放期为12个月，生产日期请参阅标签
Tujues Provence Roll Series
Using pure natural deep sea diatomite, import nanometer materials and natural inorganic silicon and other raw materials, add Natural negative ion element. Use light effect make metope can continue to remove the harmful gases such as formaldehyde, benzene, effectively eliminates the household odor, antibacterial, purify indoor air, moment family health care.
Application scope: Apply to high-grade villas, housing, hotels, business, leisure, entertainment center, etc..
Construction methods: Plastering Roll painting
Theoretical paint consumption (30 microns DFT):
30-50 square meters /barrel/two times. The actual consumption may be different due to different construction methods, wall roughness and construction environments.
ATTENTION: In order to achieve the best coating effect, according to actual construction process requirements, should stir well before the use, filter is the best.
Function:
1. Releasing anion: The product can constantly release anions which is good for human body, so that the content of indoor anions can reach the standard content of anions of the ecological prairie.
2. Adjusting the humidity ：The product can effectively adjust the humidity of indoor air and improve the indoor air quality. It can effectively contain the phenomenon of water seepage on walls especially in coastal areas and areas of plum rains.
3. Preventing mildew and resisting bacterium:The product can prevent the walls go moldy and can inhibit staphylococcus aureus and Escherichia coli up to 99%.
4. Purifying air:The product can purify the air and remove harmful gases such as indoor formaldehyde and bad smells at a rate more than 90%.
5. Photo-catalyst function:The most updated photo-catalyst of nanotechnology is used for the product.Titanium dioxide is used as the catalyst to react with the sunlight or the lamplight to resolve substances which are harmful to human body in the air and release oxygen,so as to purify the air for a long period.
PREPARATION:
PAINT SYSTEM:
Drying time (at 25℃):
2 hours to dry the surface,and 8 hours to dry and harden the layer.An interval of at least eight hours is needed for recoating. It takes 2days in summer,4 days in winter,and appropriately prolonged time in humid whether for completely hardening the layer.
APPLICATION CONDITION:
Do not apply paint on wet or cold days(Temperature below 5℃,relative humidity greater than 85%).Otherwise, desired results can not be obtained.
Maintenance time:Seven days at 25℃.In case of humid weather or too low temperature, the time shall be appropriately prolonged to achieve the best effect.
Clean：During the pause of coating or after the coating is complete,please promptly clean all utensils with clean water.
storage：
The product shall be stored in a shady,cool,dry,and airy place 0-30℃. The product shall be kept airtight for storage after the can is opened.
CAUTIONS:
•In Order To Obtain Reliable And Satisfactory Effect,Please Be Sure To Read The Method Statements On Our Product Packaging And Labeling Carefully Before Use.
•Open all the windows and doors before operation,achieve better ventilation conditions.
•Safety glasses must be worm.Especially if your skin is easy-atopic.Avoid contact with eyes.In case of contact with eyes rinse immediately with plenty of water and seek medical advice.
•Keep out of reach of children or pets.The product should be stored beyond their reach. In case of contact with them immediately with plenty of water and seek medical advice.
•Please separate ,cover and shelter wooden products and the wall region effectively.In order to maintain construction site clean,and ensure the best coating results. To avoid confusion in the construction operation.Please apply latex only after wood paint is dry.
Environmental protection matter:
There is no any harmful substance such as heavy metal in the product.It conforms to the latest national standard of the limit of harmful substances in inside wall paints and China’s technical requirements of environment products.
STANDARDS:GB/T9756-2009 GB18582-2008
Shelf life: The valid shelf life is 12 months.See the label for the production date.